Circuit-test DMR-3600 Manual do Utilizador descarregar pdf (Página 3)

TM1700-series

Circuit Breaker Analyzer System

1 2 3 4 5 6 71 2

15 16 17 19 15 20 21 22 23

Features and beneﬁts

1. Input for external clamp-on CT

2. Control section

▪ Three independent contact functions

▪ Pre-programmed sequences C, O, C–O, O–C, O–C–O

▪ Timing of a and b auxiliary contacts

▪ Coil current, voltage and resistance

3. Timing Aux section

▪ Six galvanic isolated channels

▪ Polarity insensitive

▪ Dry and wet auxiliary contacts

4. Timing M/R section

▪ Six inputs

▪ High resolution 15μV and up to 40 kHz sampling

▪ Main and parallel resistor contact timing

▪ Resistance value of parallel resistors

5. Analog section

▪ Six channels (three optional)

▪ Supports industrial analog transducers

▪ Insulated channels, measure up to 250 V whithout volt. div.

▪ High resolution 0.3 mV, sampling rate 40 kHz

6. Digital section

▪ Six channels

▪ Incremental transducers with RS422

▪ Up to ±32000 pulses resolution

▪ Up to 40 kHz sampling

7. Mains input

8. DC out

▪ General voltage source ,12 V

9. DRM

10. Earth (ground) terminal

11. Ethernet port

12. USB ports

13. Trig IN

▪ Used for external trig of the unit. Contact make / break or

voltage signal.

14. DCM interface

15. Navigation buttons

▪ Works in parallell with the touch screen buttons.

▪ Most of the CABA Local functions are controlled by the ten

navigation buttons.

16. Touch screen On/Off

17. On-screen keyboard On/Off

18. Display (touch screen)

▪ High brightness for good visibility in direct sunlight.

19. Brightness setting

20. POSITION

▪ Indicates the position of the circuit breaker main contacts if

the coil circuit is connected to the control section.

21. SEQUENCE

▪ Indicates the next operation of the circuit breaker. If Auto-de-

tect breaker state is enabled in CABA Local or CABA Win, only

possible sequences for the circuit breaker are selectable.

22. OPERATE/MEASURE

▪ Initiates the selected operation sequence and makes the mea-

surement. Green “READY” LED must be lit before turning the

rotary switch. The yellow “OPERATING” LED is lit as long as

the sequence is performed.

23. On/Off switch

1 2 3 4 5 6 7 8 ... 12 13

Comentários a estes Manuais

Sem comentários

Circuit-test DMR-3600 Manual do Utilizador Página 3

Comentários a estes Manuais

Manuais e produtos relacionados com Multímetros Circuit-test DMR-3600